PI-SUPPLYAbout UsAddress in China:Floor 10, Wisdom Building, Donghua Road Middle, Danshui Town, Huiyang district, Huizhou, Guangdong, P.R.C China, Zip code:516211 Address in Italy: Corso Liguria 6 10078 Venaria Reale(TO) ItalyPI-SUPPLY is a professional component supplier, providing everything you need for your component project. We also stock a huge selection of Raspberry pi, Arduino, micro:bit, rock pi and nvidia manufacturer accessories from your favorite brands. Our goal is to provide you with everything you need for a Raspberry Pi project - whether it's a new Raspberry pi product, a beginner looking for a Raspberry Pi 4 starter kit, or an experienced builder looking for a wide range of components. Our team works tirelessly to provi

Odroid C4
Odroid C4
Odroid C4
Odroid C4
Odroid C4
Odroid C4
Odroid C4
Odroid C4
Odroid C4

Odroid C4

Model NO.
Odroid C4
Minimum order quantity:
2 pieces
Supply Ability:
100 pieces / Day
Stock Time:
15 Days
Quantity:

Overview

ODROID-C4 is a new generation single board computer that is more energy efficient and faster performing than ODROID-C2 which was introduced over four years ago as the world’s first affordable ARM 64bit computer.

The main CPU of the ODROID-C4 is built with a quad-core Cortex-A55 cluster with a new generation Mali-G31 GPU. The A55 cores run at 2.0Ghz without thermal throttling using the stock heat sink allowing a robust and quiet computer. The CPU multi-core performance is around 40% faster, and the system DRAM performance is 50% faster than the ODROID-C2.

CPU (Amlogic S905X3)2 x System LED indicators
DDR4 memory (4GiB)1 x UART for system console
4 x USB 3.0 host ports1 x IR receiver
1 x RJ45 Ethernet port (10/100/1000)40 x GPIO pins
1 x HDMI 2.07 x GPIO pins
1 x Micro USB 2.0 port (OTG)1 x eMMC module socket
1 x DC power jack (Outer diameter : 5.5mm, inner diameter : 2.1mm)1 x Micro SD slot



The ODROID-C4 GPIO interface is similar to C2 and fully supports a 3.3Volt interface. This is beneficial for using various peripherals without complicated level shifters as with the XU4’s 1.8Volt GPIOs. Another big improvement is a faster SPI bus interface with a maximum frequency of about 100Mhz. It is significantly faster than the ODROID-C2’s 400Khz software “bit-banged” SPI.
 

Note:

  • The power consumption in “IDLE” is measured when a device is not being operated for 5 minutes since the CPU governor is set to ‘performance’.
  • The measured power consumption is not absolute and could vary in certain conditions.

Specifications

Form factorBoard Dimensions: 85mm x 56mm x 1.0mm

Heatsink Dimensions: 40mm x 32mm x 10mm

Weight: 59g including heatsink

ProcessorAmlogic S905X3 12nm Processor

L1 instruction cache: 32 KB, 4-way set associative (128 sets), 64 byte lines, shared by 1 processor

L1 data cache: 32 KB, 4-way set associative (128 sets), 64 byte lines, shared by 1 processor

L3 data cache: 512KB , 16-way set associative (512 sets), 64 byte lines, shared by 4 processors

Quad-Core Cortex-A55 (2.016GHz)

ARMv8-A architecture with Neon and Crypto extensions

Mali-G31 MP2 GPU with 4 x Execution Engines (650Mhz)

MemoryDDR4 4GiB with 32-bit bus width

Data rate: 2640 MT/s (PC4-21333 grade)

1.2Volt low power design

Storage1x eMMC connector (8/16/32/64GiB are available)

1x Micro SD slot (DS/HS mode up to UHS-I SDR104)

Networking1 x GbE LAN ports (RJ45, supports 10/100/1000 Mbps)

– Realtek RTL8211F (Ethernet transceiver)

– LED indicators

* Green LED: Flashing by data traffic at 100Mbps connection

* Amber LED: Flashing by data traffic at 1000Mbps connection

Optional WiFi USB adapters

Video1 x HDMI 2.0 (up to 4K@60Hz with HDR, CEC, EDID)
Audio1 x HDMI digital output

1 x Optional SPDIF optical output

External I/O4 x USB 3.0 Host ports (shares one single root hub)

1 x USB 2.0 OTG port for Host or Device mode. (No power input)

1 x Debug serial console (UART)

1 x Peripheral Expansion Header (40-pin, 2.54mm pitch)

  • 2x DC 5V, 2x DC 3.3V, 1x DC 1.8V, 8x GND
  • 1x SPI
  • 1x UART
  • 2x I2C
  • 6x PWM
  • 2x ADC input (12bit, 1.8V Max)
  • 25x GPIO (Max)

1x Audio Expansion Header (7-pin, 2.54mm pitch)

  • 1x DC 5V
  • 1x SPDIF out
  • 1x I2S

– All 3.3V I/O signal level except for ADC input at max 1.8Volt.

Other featuresIR receiver for remote controller

System LEDS Indicators:

– Red (PWR) – Solid light when DC power is connected

– Blue (ALIVE) – Flashing like heartbeat while Kernel is running.

Power1 x DC jack : outer (negative) diameter 5.5mm, inner (positive) diameter 2.1mm

DC input :  5.5V ~ 13V  (*15V/4A PSU is not compatible with C4)

– DC 12V/2A power adaptor is recommended

Power consumption:

– IDLE : ≃ 1.8W

– CPU Stress : ≃ 3.64W (Performance governor)

– Power-off : ≃ 0.14W


 

Send Inquiry

* clear input
* clear input
* clear input
* clear input
*

Related Products

Model NO. ROCK PI 0 1GB
Model NO. Radxa Zero
Preview on Mobile
X
customer-service Customer Service
whatsapp WhatsApp
skype Skype
wechat WeChat
message Message
go top Top
WeChat Close
qr code
+86-18948255021
qrcode

Send Inquiry

* clear input
* clear input
* clear input
* clear input
*
Choose language